Course Outline		Schedule

Utilization and Support of Load Port "Porta 300" Product Line

This document is an outline of a standard course layout, applicable for all configurations of Genmark’s load ports

Section 1 - Introduction

This part of the course contains the general information about the equipment, its operation and features of the Genmark’s utility program.

1. The safety precautions
2. Standard and optional features
3. Specifications
4. Operation of the load port
5. “Gencobot Tool Box” utility

Section 2 - Design of the Porta 300

This part of the course describes in detail all of the main assemblies of the Porta 300. Following topics are covered:

1. Porta 300 door assembly
2. Load/Unload port assembly
3. Porta 300 interface assembly
4. Control assembly
5. Cart assembly

Section 3 - Installation and Removal

This part of the course, teaches how to install and uninstall Porta 300 onto and from a Host Unit. In addition provides information on alignment of the load port, necessary after installation of the unit.

1. Steps taken during installation of Porta 300
2. Installation procedure
3. Performing of the alignments procedures
4. Porta 300 removal